Rule LoPro 900GPH Bilge Pump - Non-Automatic Marine Plumbing & Ventilation
Our latest automatic pump design, the LoPro, allows pumping in tight spaces and shallower holds. The e LP900D uses a unique dual water sensing system, to ensure the pump only runs when water is present and effectively turns off when it is not. If water is detected, the pump will spin the impeller for a double check. If water is confirmed, the pump will operate to empty the bilges. The pump body rotates to allow discharge in any direction. A selection of straight and 90 degree ports, as well as a check valve for use with straight ports, are provided.
LP900D Rule Attributes- Type: Submersible
- Rated voltage: 12 V DC
- Flow rate: 900 gallons per hour
- Length: 2.4 inches
- Width: 2.4 inches
- Height: 7.6 inches
- Includes twox automated operating modes
- High or low water detection mode. The pump starts when the water reaches 2 inches by turning the motor cartridge upside down, the sensor is 1.3 inches
- Electronic automatic mode The pump turns on automatically every 2.5 minutes to check for the presence of water, and if detected, the pump remains on until the water disappears
- Fully rotating discharge body; The entire body swivels up to 180 degrees, making the pump extremely easy to install.
- Backflow prevention; New tricuspid check valves help prevent backflow
- Horizontal or vertical mounting; Feature a variety of mounting options to fit the boat's bilge
- 3 year limited warranty
- lp900d -instruction-manual2.pdf
- lopro-bilge-pumps-sales-flyer.pdf
LoPro 900GPH Bilge Pump - Non-Automatic
The Rule LoPro 900 Non-Automatic is a low profile bilge pump with a capacity of 900 gallons per hour . Designed for tight spaces, the pump height is only 2-1/4".
It features a special threaded discharge nozzle to which you can attach either a straight fitting or a 90° fitting ( included). Additionally, you can use the tricuspid check valve {included} on the straight fitting to minimize water backflow. The entire discharge body rotates up to 180° for easy installation. The attached hose can also rotate 360° to route the hose perfectly
Features:
- Low profile 900 GPH bilge pump
- Fits hard to reach places
- Non-automatic, requires float and/or panel switch to automate
- Threaded discharge ports with multiple fittingsavailable
- Includes a tricuspid check valve to minimize water backflow
This product may expose you to chemicals including STYRENE, which is known to the State of California to cause cancer. For more information,
Lopro 900gph Bilge Pump - Non-Automatic Rules The Lopro 900 Non-Automated is a basump profile bilge pump with a processing capacity of 900 gallons per hour. Designed for small spaces, height...
PRODUCT ID: 54195
SKU: NVN-54195
CSKU: CWR-54195
REWRITE: 65306-rule-lopro-900gph-bilge-pump -non -automatic
MPN: LP900D
UPC: 042237114365
ASIN: B00FM26GEK
WSKU:
SSKU:
KSKU: X69LP900D
GSKU:
MSKU:
LSKU:
NAME: Rule LoPro 900GPH Bilge Pump - Non-Automatic
NAME_EX: RULE LOPRO 900 GPH NON-AUTOMATIC Bilge Pump
PTITLE: Rule LoPro 90 Bilge Pump0GPH - Non-automatic
TYPE: Marine Plumbing and Ventilation | Bilge Pumps
SELLER: Rule
VEHICLES & PARTS> VEHICLE PARTS & ACCESSORIES> POWERWATER PARTS & ACCESSORIES
Automotive Parts & Accessories
Rule 3004.7723 LP900D LoPro Bilge Pump - 900 GPH
Rule LoPro 900GPH Bilge Pump - Non-Automatic
Automotive Parts & Accessories
Gtags:
| Boat |
GSpecs:
Rule LoPro 900GPH Bilge Pump - Non-Automatic Product Description
Our latest automatic pump design, the LoPro helps pump out of tight spaces and shallower bilges. The e LP900D uses a unique dual water sensing system, to ensure the pump only runs when water is present and effectively turns off when it is not. If water is detected, the pump will spin the impeller for a double check. If water is confirmed, the pump will operate to empty the bilges. The pump body rotates to allow discharge in any direction. A selection of straight and 90 degree ports, as well as a check valve for use with straight ports, are provided.
LP900D Rule Attributes- Type: Submersible
- Rated voltage: 12V DC
- Flow: 900 gallons per hourspan>
- Length: 2.4 inches
- Width: 2. 4 inches
- Height: 7.6 inches
- Features two automated operating modes
- High or low water sensing mode, the pump starts when the water reaches 2 inches by flipping the motor cartridge, the sensor is at 1.3 inches
- Electronic automatic mode, the pump automatically turns on every 2.5 minutes to check for the presence of water, and if detected, the pump stays on until the water disappears . Fully rotating discharge body; The entire body swivels up to 180 degrees, making the pump extremely easy to install.
- Backflow prevention; New tricuspid check valves help prevent backflow
- Horizontal or vertical mounting; Feature a variety of mounting options to accommodatepter to the boat's hold
- 3 year limited warranty
- lp900d-instruction-manual2.pdf
- lopro-bilge-pumps-sales-flyer.pdf
LoPro 900GPH Bilge Pump - Non-Automatic
The Rule LoPro 900 non-automatic is a low profile bilge pump with a capacity of 900 gallons per hour. Designed for tight spaces, the pump height is just 2-1/4".
It features a threaded discharge nozzle to which you can attach a straight fitting or a 90° fitting (included ) Additionally, you can use the tricuspid check valve {included} on the straight fitting to minimize water backflow. The entire discharge body rotates up to 180° for easy installation. attached hose can also rotate 360° to route the hose perfectly>
Features:
- Low profile 9 bilge pump.00 GPH
- Fits hard to reach places
- Non-automatic, requires float and/or panel switch to automate
- Threaded discharge ports with multiple fittings available
- Includes a tricuspid check valve to minimize water backflow
This product can expose you to chemicals including STYRENE, which is known to the State of California to cause cancer. For more information,
Lopro 900gph Bilge Pump - Non-Automatic Rules The Lopro 900 Non-Automated is a low profile bilge pump with a 900 gallon processing capacity. per hour. Designed for small spaces, heights...
Rule LoPro 900GPH Bilge Pump - Non-Automatic Related ProductsBoatLIFE Silicone Rubber Sealant Cartridge - Clear
Silicone Rubber Sealant CartridgeBoatLIFE - White
BoatLIFE Silicone Rubber Tube – 2.8 FL. Oz - Clear
BoatLIFE Silicone Rubber Tube - 2.8 FL. Oz - White
Frequently Asked Questions (FAQ) About Rule LoPro 900GPH Bilge Pump - Non-Automatic Who is the Rule?
How to Describe the Rule LoPro 900GPH Bilge Pump - Non-automatic -Automatic?
What is the operating voltage of the product?
What is the type of product?
What is the rule of the LoPro 900GPH bilge pump - Dimensions and packaging no automatic weight?
What is the height of the product?
What is the length of the product?
What is the length of the product?
What is the operating mode of the product, automatic?
What is the working capacity of the product (GPM)?
What is the working capacity of the product (GPH)?
Who is the rule? In 1998, Rule was acquired by ITT Corporation and became part of the Marine & Leisu family of companiesD. Rule is a global leader in submersible bilge pumps for the recreational boat and small commercial boat markets and a leading supplier of accessory products such as ventilation fans and winches. Look for the Rule name and vague logo when you need the best product performance and durability. How to describe the Rule LoPro 900GPH Bilge Pump – Non-Automatic? Lopro 900gph Bilge Pump - Non-Automatic Rules The Lopro 900 Non-Automated is a low profile bilge pump with a handling capacity of 900 gallons per hour. Designed for small spaces, height...WhWhat is the operating voltage of the product? 12v What is the type of product? SubmersibleWhat is Rule LoPro 900GPH Bilge Pump - Non-Automatic Package Dimensions and Weight? 2.4 inches (w) X 7.6 inches (h) X 2.4 inches (w) inches and the weight is: lbs. What is the height of the product? 7.6 inchesWhat is the length of the product? 2.4 inchesHow long is the product? 2.4 inchesWhat is the working mode of the product, automatic? Non-automaticWhat is the product's working capacity (GPM)? 15 GPMWhat is the working capacity of the product (GPH)? 900 GPH
Save $24 when you purchase the Rule LoPro 900GPH Bilge Pump - Non-Automatic for only $50 at NVN Marine! Same day dispatch before 3 p.m. Rule LoPro 900GPH Bilge Pump - Non-Automatic Technical Specifications
| Type: | Marine Plumbing and Ventilation | Bilge pumps |
|---|---|
| Supplier: | Rule |
| Weight: | 1.5 lbs |
| Volts: | 12v |
| Operation: | Non-Automatic |
| Gallons per minute: | 15 GPM |
| Gallons pertime: | 900 GPH |
| Type: | Electric |
| Product brochure: | Download PDF |
| Shipping Weight: | 1 .5 lb |
|---|---|
| Box sizes: | 4.00 (h) x 8.00 (w) x 10 .00 (l) |
| Cubic feet: | 320.0 |
| Returnable: | Yes |
| P65: | Yes |
For detailed shipping policy, please see our Shipping Policy and you can find our return and refund policy here .
- Rule LoPro 900GPH Bilge Pump - Automatic
- Rule 3" Inline Bilge Blower - 24V
- Rule iL500 Plus Inline Pump Kit - 12V
- Rule IL500 Plus In-Line Submersible Pump 7 gpm 12 V
- Rule IL200 Plus In-Line Submersible Pump 24 V 2.8 GPM
- Rule IL200 Plus In-Line Submersible Pump 2.8 gpm 12 V
- Rule IL200 In-Line Submersible Pump Kit 2.8 gpm 12 V
