Octopus linear drive mounted on 7" stroke 38 mm bore - 12 V - up to 45' or 24200 lbs Marine Navigation & Instruments
Octopus offers a complete range of powerful, low current consumption hydraulic linear drives designed for long runs. An independent comparison by the University of British Columbia* showed that Octopus piston pumps are three times more efficient than a gear pump and should cut battery consumption in half compared to the competing unit , thus doubling the effective range of the autopilot on one battery charge. A linear drive that does not have variable flow (unless it is dedicated to a range of yachts) will run too fast or too slow 90% of the time. Autopilot manufacturers get around this problem by adjusting the pump flow to compensate. However, either this forces the pump to run for longer periods, increasing power consumption and wear on parts, or the pump will operate at high pression for short periods of time, which also places unnecessary strain and wear on the system. p>Octopus AF1012LAM7 Attributes
- Compatibility: Boats up to 45 feet long
- Drive type: Linear hydraulic
- Stroke length: 7 inches
- Maximum thrust: 882 pounds
- Input voltage: 12 V
- Motor current rating: 19 A
- Reliable: only three moving parts, Increased reliability
- Efficient: three times more efficient, battery consumption cut in half
- Adjustable flow: configure performance depending on your vessel
- Octopus linear drives are available With a wide range of strokes and pump sizes
- 2 year limited warranty
Linear actuators
OCTAF1012LAM7
An Octopus hydraulic linear actuator is a simple and effective means of pilremove the rudder on a boat equipped with a mechanical steering system. The linear actuator is an assembly of an Octopus reversing pump and a marine hydraulic cylinder. This assembly is mounted on the tiller or rudder quadrant. When the autoisland is not in use, the cylinder rotates freely with the rudder. When the autopilot is used, a solenoid valve on the actuator closes and locks the cylinder. Steering signals from the pilot are now transmitted to the DC motor, which drives the pump to move the cylinder back and forth. When powered off, the solenoid valve immediately disconnects the autopilot from the rudder. The actuator has a small translucent oil reservoir, making it easy to check fluid levels. These actuators have only five moving parts. Mechanical simplicity gives our product reliability and ease of maintenance compared to gear and screw actuators.lexes, which makes our units preferred by offshore sailors. These actuators are shipped from our factory fully filled with oil and require no additional plumbing.
Features
The Octopus autopilot hydraulic linear actuator up to 45 or 24,200 lbs. The 7-stroke is a simple and effective way to operate a rudder equipped with a mechanical steering system. Linear actuator is a component of Octopus reversing pump and marine hydraulic cylinder. The component is installed on the baserre straight or the quadrant.
PRODUCT ID: 44316
SKU: NVN-44316
CSKU: CWR-44316
REWRITE: 55427-octopus-7-stroke-Mounted-38mm- linear bore
MPN: OCTAF1012LAM7
UPC: 628309134679
ASIN: B00MYSY04S
WSKU: OTPOCTAF1012LAM7
SSKU: OCT-OCTAF1012LAM7
KSKU: OCTAF1012LAM7
GSKU:
MSKU:
LSKU :
NAME: Octopus 7" Race Mounted Linear Drive, 38mm Bore - 12V - up to 45' or 24,200 lbs
NAME_EX: OCTOPUS 7" RACEMOUNTED LINEAR DRIVE 38MM 12V
br>PTITLE: Octopus 7" Stroke38mm Bore Mounted Linear Drive - 12V - Up to 45' or 24,200 lbs
TYPE: Navigation & Marine Instruments | Autopilots
SELLER: Octopus Autopilot Drives
VEHICLES & PARTS> VEHICLE PARTS & ACCESSORIES> WATERCRAFT PARTS & ACCESSORIES> WATERCRAFT STEERING PARTS> WATERCRAFT STEERING CABLES
GPS or Navigation System
Octopus 7" Race Mounted Linear Drive, 38mm Bore - 12V - Up to 45' or 24,200 lbs
GPS or Navigation System
Gtags:
GSpecs:
Octopus offers a complete line of powerful, low current consumption hydraulic linear drives, designed for completing long passages An independent comparison from the University of British Columbia* showed that Octopus piston pumps are three times more efficient than a gear pump and can cut battery consumption in half. compared to the competing unit, thus doubling the effective range of the autopilot with a single battery charge which does not have variable flow (unless dedicated to a range of yachts) will operate too quickly or too slowly in. 90% of cases autopilot manufacturers get around this problem by adjusting the pump flow to compensate, forcing the pump to run for longer periods, which increases power consumption.energy and wear of parts, or the pump will operate at high pressure for short periods of time, which also places unnecessary pressure and wear on the system.
Attributes of the Octopus AF1012LAM7- Compatibility: Boats up to 45 feet Long
- Drive Type: Linear hydraulic
- Stroke length: 7 inches
- Maximum thrust: 882 pounds
- Input voltage: 12 volts
- Motor Rating: 19 Amps
- Reliable: Only three moving parts, increased reliability
- Efficient: three times more efficient, half the battery consumption
- Adjustable flow: configure performance to suit your vessel
- Octop linear drivesus are available with a wide range of strokes and pump sizes
- 2 year limited warranty
Linear actuators
OCTAF1012LAM7
An Octopus hydraulic linear actuator is a simple and effective way to control the rudder on a boat equipped with a mechanical steering system. The linear actuator is an assembly of an Octopus reversing pump and a marine hydraulic cylinder. This assembly is mounted on the tiller or rudder quadrant. When the autopilot is not used, the ram rotates freely with the rudder. When the autopilot is used, a solenoid valve on the actuator closes and locks the cylinder. Steering signals from the pilot are now transmitted to the DC motor, which drives the pump to move the cylinder back and forth. When powered off, the solenoid valve immediately disconnects the autopilot from the rudder. The actuator has a small reservoirTranslucent oil, making it easier to check fluid levels. These actuators have only five moving parts. Mechanical simplicity gives our product reliability and ease of maintenance compared to complex gear and screw actuators, making our units preferred by offshore sailors. These actuators are shipped from our factory completely filled with oil and require no additional plumbing.
Features
The Octopu autopilot hydraulic linear actuators up to 45 or 24,200 pounds. The 7-stroke is a simple and effective way to operate a rudder equipped with a mechanical steering system. Linear actuator is a component of Octopus reversing pump and marine hydraulic cylinder. The component is installed on the tiller bar or quadrant.
Frequently Asked Questions (FAQ) about Octopus 38mm Bore 7" Stroke Mounted Linear Drive - 12V - up to 45' or 24,200 lbs. Who is the Octopus Autopilot Drive? How to Describe OcTopus 7" Stroke Mounted Linear Drive, 38mm Bore - 12V - Up to 45' or 24,200 lbs? What is the type of product?
What is the compatibility of this product?
Who is Octopus Autopilot Drives? Octopus is a division of Canada Metal (Pacific) Ltd. and designs, manufactures and markets drives. of autopilot for more than 20 years.me of Octopus marine autopilot drive systems. lines as well as the expertise of their engineering and machining divisions allowed this acquisition to further strengthen our company's capabilities to meet the ever-growing needs of our customers. How to describe the Octopus 7" Linear Drive Mounted on 38mm Stroke and Bore - 12V - up to 45" or 24,200 lbs? The Octopus Autopilot hydraulic linear actuator up to 45 or 24,200 lbs. The 7-stroke is a simple and effective way to operate a rudder equipped with a mechanical steering system. Linear actuator is a component of Octopus water pump inverter and marine hydraulic cylinder. The component installs on the tiller or quadrant.
- Drive the rudder on a boat
- Simple and effective
- No more struggling with ropes
- The linear actuator is a simple and effective way to drive the rudder on aboat
- The marine linear actuator is an assembly of an Octopus reversing pump and a marine motor
- The actuator assembly works with any steering system mechanical
- Operating the rudder on a boat
- Simple and effective
- No more struggling with the ropes
- The actuator linear actuator is a simple and effective way to drive the rudder on a boat
- The marine linear actuator is an assembly of an Octopus reversing pump and a boat
- Actuator assembly works with any mechanical steering system
- Pump is designed for use with a variety of fluids including water, oils, coolants and other chemicals .ls.
- It is suitable for a wide range of industries such as food processing, chemical manufacturing and pharmaceutical, automotive repair shops and the mining industry.
- The pump can be used in many different applications, including residential irrigation systems.
- The AF1012LAM7 pump is the ultimate in power and efficiency.
- It is a linear drive pump with a 7" stroke and a maximum flow rate of 5,000 cc/min.
- The pump comes with an octopus manifold, ideal for mounting on your engine block.
Save $776 on the purchase of the Octopus 7" stroke-mounted linear drive, 38 mm bore - 12 V - Up to 45' or 24,200 lbs for only $1,619 from NVN Marine! Free same day delivery before 3 p.m. Octopus 7" Stroke Mounted Linear Drive, 38mm Bore - 12V - Up to 45' or 24,200 lb Technical Specifications
| Type: | Navigation and maritime instruments | Autopilots |
|---|---|
| Supplier: | Octopus Autopilot Drives |
| Weight: | 20.5 lbs |
| Type: | Pumps/Drives |
| User Guide: | Download PDF |
| Shipping Weight: | 20.5 lbs |
|---|---|
| Box sizes: | 8.00 (h) x 8.00 (l) x 39.00 (l) |
| Cubic feet: | 2496.0 |
| Returnable: | Yes |
For detailed shipping terms, please see our shipping policy and you can find our return and refund policy here.
- Octopus 38mm Bore Cylinder Seal Kit
- 30" Octopus Pipe and Fittings Kit Includes Orb and NPT Bar Fittings
- Octopus 12" linear drive with 45 mm distance - 12 V - Up to 80' or 44000 lbs
- Octopus 12" 38 mm remote linear drive - 12 V - Up to 60' or 33000 lbs
- Octopus 12" linear drive mounted on 38mm stroke 12V - up to 60' or 33000 lbs
- OceanLED XP Series DMX Junction Box
- 3M OceanLED XP Series DMX Application Cable
